Lambda measurement system LCU – 4

The LCU – 2 lambda measurement system was primarily developed for use in conjunction with AIM displays and data loggers and can also be used with devices from other manufacturers and in conjunction with many engine control units.

The LCU – 2 lambda measurement system was developed for Designed for use with AIM displays and data loggers. In addition, it can also be used with devices from other manufacturers and in conjunction with many engine control units (ECU).

In the CAN network (Controller Area Network) with the MXL, you can operate up to 12 LCUs at the same time. The LCU – 2 can also be used on engines that do not run on gasoline, but on methanol, gas, diesel, etc., because the configuration software also allows the 1 parameters to be changed.

The LCU – 2 is a control device for the BOSCH LSU 4.9 broadband lambda sensor. Its task is to control and monitor the correct function of the lambda sensor and its heating and to output the lambda value determined from the residual oxygen content of the exhaust gas either via the analog output or digitally via CAN.